Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 59)

3–36 Front Panel Editor
Publication 2706–816
To check the fault diagnostic LED:
This displays the status of the Fault LED. Its location on the back of
the terminal is shown in the diagram on Page 1–4.
1. Highlight Fault Diag. LED and press to display whether the
LED on the back of the terminal is Off (no problem) or On.
Fault Diag. LED
Off
If the LED is On, see Page 7–3.
2. Press the Ack key to return to the System Status submenu.
3. Press Ack again to return to the FPE menu.
To check the firmware status:
This displays the version number of the embedded firmware code.
1. Highlight Firmware Status and press to display the version
number of the firmware.
Firmware Status
V2.00
2. Press the Ack key to return to the System Status submenu.
3. Press Ack again to return to the FPE menu.
To check the name of the application currently installed:
This displays the name of the current application.
1. Highlight Application Name and press to display the name.
Application Name
SMD-Line
2. Press the Ack key to return to the System Status submenu.
3. Press Ack again to return to the FPE menu.