Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 50)

3–27 Front Panel Editor
Publication 2706–816
To perform the Communication Card Test
This verifies the communication connection between the internal
Main Logic Board and the protocol-specific Remote I/O
daughterboard. (The RS-232 port is checked in the Com Ports test.)
1. Highlight Communication Card Test and press to run the
test.
The result of the test is displayed at once.
Communication
Test Passed
Card Test
If the test fails, see Page B–4.
2. Press the Ack key to return to the Self Tests submenu.
3. Press Ack again to return to the FPE menu.
To perform the Application Test
This verifies the validity of the application stored in the terminal. An
application is a program designed and downloaded using the
MessageBuilder software.
1. Highlight Application Test and press to run the test.
The result of the test is displayed at once.
Application Test
Test Passed
If the test fails, see Page B–4.
2. Press the Ack key to return to the Self Tests submenu.
3. Press Ack again to return to the FPE menu.