Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 58)

3–35 Front Panel Editor
Publication 2706–816
To check the boot code status:
This displays the version of the embedded boot code.
1. Highlight Boot Status and press to display the version
number of the boot code.
Boot Status
V01.01
2. Press the Ack key to return to the System Status submenu.
3. Press Ack again to return to the FPE menu.
To check the Remote I/O communication diagnostic LED:
This displays the status of the Comm LED. Its location on the back
of the terminal is shown in the diagram on Page 1–4.
1. Highlight Comm Diag. LED and press to display whether
the LED on the back of the terminal is On (RIO communications
active) or Off (RIO communications not active).
Comm Diag. LED
On
If the Comm LED is Off, and you can see no reason for its state
in this table, see Page 7–3.
If the terminal If the terminal is in:
The Comm. LED should
be:
does not have a
daughterboard
any mode Off
has a daughterboard Run Mode On
Simulate function Off
Debug Mode On
2. Press the Ack key to return to the System Status submenu.
3. Press Ack again to return to the FPE menu.