Rockwell Automation 2755-DM9, -DM9E High Speed Decoder User Manual
Page 142
Appendix A
Setting Up the Programming Terminal
A–5
If you are using an Allen-Bradley 1770-T1, -T2, or -T3 programming
terminal, follow these steps:
Step 1 - Connect the scan head to the decoder.
Step 2 - Construct an appropriate cable to connect the decoder to the
terminal (Channel B). Refer to Figure A.6.
Figure A.6
Connections for Cable Used With 1770-T1, -T2, or -T3 Terminals
•
AUX Port on Decoder -DCE
Note: Connect shield to shell of
cable connectors at both ends.
2
3
7
2
3
Transmit Data
Receive Data
Signal Ground
7
Connector:
25-pin, female
connector.
Cable:
Belden 9939 or
equivalent
1770 -T1, -T2,
or -T3.
All DTE Devices
18
25
•
Step 3 - Plug decoder and terminal into power supply.
Step 4 - Turn terminal ON.
Step 5 - Select Alphanumeric mode and set the following parameters:
•
Baud Rate = 9600
•
Parity = None
•
Stop Bits = 1
•
Channel Config. = B IN/OUT
•
Duplex = Full
•
Channel C = On or Off
•
Cursor = On
•
Auto Line Feed After Return = Off
•
Control Code Display = Off
Note: Use the [Ctrl] and U, D, L, or R keys for Up, Down, Left, and Right
cursor movement.
Step 6 - Turn the decoder ON.
Step 7 - Proceed with programming the system as described in Chapter 4.
Using a Catalog Number
1770-T1, -T2 or -T3 Terminal for
Programming