Rockwell Automation 2755-DM9, -DM9E High Speed Decoder - Manual (Page 70)

Chapter 4
Configuring Your Decoder
4–43
10) Press the [RETURN] key to enter the No-Read message and then press
the [ESC] key to select the command bar. Notice that the five commands are
shown on the bottom of the display:
------- MESSAGE FORMAT ------- ------- HOST COMM -------
SEND BAR CODE DATA: Yes BAUD RATE: 9600
SEND PACKAGE COUNT: No BITS/CHAR: 8 Data, 1 Stop
SEND BAR CODE TYPE: No PARITY: None
SEND SOURCE IDENTIFIER: No
SEND HEADER MESSAGE: No ACK CHAR: None
SEND NO-READ MESSAGE: Yes NAK CHAR: None
START SCAN CHAR: None
EXPAND UPC-E: Yes STOP SCAN CHAR: None
SOURCE IDENTIFIER: LARGE BUFFER: No
LABEL DELIMITER: None RESPONSE MODE: Valid Package
START CHAR: None HOST PROTOCOL: RS232
END MESSAGE: CRLF DEVICE ADDRESS: 01
TRANSMISSION CHECK: None
HEADER MESSAGE:
NO-READ MESSAGE: NO-READ
CODE 39 CHECK CHAR: No SEND: No ---PACKAGE DETECT INPUT---
I 2-OF-5 CHECK CHAR: No SEND: No FILTER: No
CODABAR CHECK CHAR: No SEND: No SENSE: LO = Package
COMMAND -- Exit: ESC Select: RETURN Next Command: SPACE
NEXT PAGE THIS PAGE RECALL SAVE DEFAULT
11) Notice that the NEXT PAGE command is highlighted. Press the
[RETURN] key to enter the command. The next setup screen will be
displayed:
-- SYMBOLOGY -- -------- LENGTHS -------- -------- SCANNER CONTROL --------
CODE 39: Yes 00 00 00 00 00 00 00 00 LASER-ON MODE: Continuous
I 2-OF-5: No 00 00 00 00 00 00 00 00 DECODE TRIGGER: Package Detect
CODE 128: No 00 00 00 00 00 00 00 00 CAPTURE COUNT: 2 (scans)
CODABAR: No 00 00 00 00 00 00 00 00 FIELDS/SCAN: 1
UPC-A: No FIELDS/PACKAGE: 1
UPC-E: No NO-READ TIMER: 0000 (msec)
EAN-8: No INTER-SCAN TIMER: 0000 (msec)
EAN-13: No MATCH COMPLETE: 1
------------MATCH CODE TABLE-------------- --------- OUTPUTS [DISABLED]---------
1) CODE 39 N
None 0000
2) CODE 39 N None 0000
3) CODE 39 N None 0000
4) CODE 39 N None 0000
5) CODE 39 N None 0000
6) CODE 39 N None 0000
7) CODE 39 N None 0000
8) CODE 39 N None 0000
Commands: ESC Change: SPACE Cursor Control: ARROWS