Rockwell Automation 20L, LPM20 PowerFlex 700 Active Converter Power Module - Manual (Page 15)

Installation/Wiring 1-5
PowerFlex 700L Active Converter Power Module User Manual
Publication PFLEX-UM002D-EN-P
Figure 1.3 Active Converter Control Cassette I/O Terminal, Cable Connection, and
DPI SLAVE/MASTER Switch SW1 Locations
I/O Terminal Blocks
Table 1.A Active Converter Control Board I/O Terminal Block Specifications
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
2
1
4
3
6
5
7
Active Converter
Control PCB Assembly
J1 40-Pin
Ribbon Cable
Header
J9 Synchronization
Cable Header
(700S Ph. II Control only)
P1-7 and P1-8
Synchronization
Cable Connection
(700 Vector Control only)
P1-13 and P1-14
Factory-Installed
Gate Kill Jumper
J4 Internal DPI
Cable Header
Voltage Feedback
Resistor PCB Assembly
P1 I/O Terminals
(see Table 1.B for
terminal descriptions)
P2 I/O Terminals
(see Table 1.C for
terminal descriptions)
SW1
SW1
ON
ON
DPI SLAVE = OFF
DPI MASTER = ON
J2 30-Pin
Ribbon Cable
Header
Name Description
Wire Size Range (1)
(1) Maximum/minimum that the terminal block will accept - these are not recommendations.
Torque
Maximum Minimum Maximum Recommended
I/O Blocks Signal and power
connections 1.5 mm 2
(16 AWG)
0.14 mm 2
(28 AWG)
0.25 N-m
(2.2 lb.-in.) 0.22 N-m
(1.9 lb.-in.)