Rockwell Automation 20L, LPM20 PowerFlex 700 Active Converter Power Module - Manual (Page 19)

PowerFlex 700L Active Converter Power Module User Manual
Publication PFLEX-UM002D-EN-P
Chapter
2
Start Up
The start-up procedure built into the HIM addresses only the start up of the
inverter. This chapter describes how to start up the PowerFlex 700 Active
Converter Power Module.
Establishing
Communication as a
Coupled Unit When the Converter is set to operate as a Coupled unit (DPI SLAVE), the
first step after turning on power is to verify that you are able to
communicate with the unit and that it properly displays selected data.
Data is exchanged between the Inverter Power Module and Active
Converter Power Module to pass control and status information.
An example is given for how to communicate with the Active Converter
Power Module using a CIP message from a ControlLogix controller.
Accessing Active Converter Power Module Parameters
The Active Converter operates as a DPI peripheral on port 6. This section
describes how to access parameters in the Active Converter.
Using the HIM
1. On power up, the HIM displays the main menu and communicates with
the Inverter.
2. As you scroll down to “Device Select,” the HIM shows the following
indication. With “Device Select” highlighted, press the Enter key.
For information on… See page…
Establishing Communication as a Coupled Unit 2-1
Establishing Communication as a Stand Alone Unit 2-8
Converter Sequencing
2-12
Control Setup 2-14
Converter Faults 2-17
F-> Stopped Auto
0.0 RPM
Main Menu:
Diagnostics
Parameter
Device Select
F-> Stopped Auto
0.0 RPM
Main Menu:
Parameter
Device Select
Memory Storage