Rockwell Automation GV3000/SE, VTAC 7 Super Remote Meter Interface Board M/N 2SI3000 M/N 2SI3000E - Manual (Page 30)

3-16 Super Remote Meter Interface (RMI) Board
3.4 Installing the RMI Board in 30 to 100HP@230VAC
and 75 to 200 @ 460VAC Drives
Use this procedure to install the RMI board in the drives listed in table 3.5.
Unless otherwise indicated, keep all hardware that is removed. You will need it for
reassembly. This includes screws, lock washers, and rivets.
Important: Read and understand the warning labels on the outside of the drive
before proceeding.
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should install, adjust, operate, or service this equipment. Read and
understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in
severe bodily injury or loss of life.
ATTENTION: The drive is at line voltage when connected to incoming
AC power. Disconnect, lock out, and tag all incoming power to the drive
before performing the following procedure. Failure to observe this
precaution could result in severe bodily injury or loss of life.
ATTENTION: DC bus capacitors retain hazardous voltages after input
power has been disconnected. After disconnecting input power, wait five
minutes for the DC bus capacitors to discharge and then check the
voltage with a voltmeter to ensure the DC bus capacitors are discharged
before touching any internal components. Failure to observe this
precaution could result in severe bodily injury or loss of life.
ATTENTION: The drive contains printed circuit boards that are
static-sensitive. An anti-static wrist band should be worn by any person
who touches the drive’s components, connectors, or wiring. Erratic
machine operation and damage to, or destruction of, equipment can
result if this procedure is not followed. Failure to observe this precaution
could result in bodily injury.
Table 3.5 – Model Numbers for 30 to100 HP @ 230 VAC and 75 to 200HP @ 460VAC Drives
30 to 100HP @ 230VAC 75 to 200HP @ 460VAC
GV3000/SE Drives VTAC 7 Drives GV3000/SE Drives VTAC 7 Drives
30V20xx 30W21xx 75V40xx 75H41xx
75W41xx
40V20xx 40W21xx 100V40xx 100H41xx
100W41xx
50V20xx 50W21xx 125V40xx 125H41xx
125W41xx
60V20xx 60W21xx 150V40xx 150H41xx
150W41xx
75V20xx 75W21xx 200V40xx 200W41xx
100V20xx 100H21xx