Rockwell Automation GV3000/SE, VTAC 7 Super Remote Meter Interface Board M/N 2SI3000 M/N 2SI3000E - Manual (Page 7)

List of Tables V
List of Tables
Table 2.1 – Jumper Selections for Digital Output Supply Source............................. 2-2
Table 2.2 – Relay Contacts ...................................................................................... 2-3
Table 2.3 – Analog Outputs ...................................................................................... 2-3
Table 3.1 – Locating the Appropriate Installation Procedure ................................... 3-1
Table 3.2 – Model Numbers for 1 to 5HP@460VAC Drives.................................... 3-4
Table 3.3 – Model Numbers for 7.5 to 10 HP @ 460 VAC Drives............................. 3-8
Table 3.4 – Model Numbers for 1 to 20 HP@ 230VAC Drives................................ 3-12
Table 3.5 – Model Numbers for 30 to100 HP @ 230 VAC and
75 to 200HP @ 460VAC Drives ......................................................... 3-16
Table 3.6 – Model Numbers for 15 to 25HP and 25 to 60HP @ 460VAC Drives .. 3-21
Table 3.7 – Model Numbers for 200 to 400 HP @ 460VAC Drives........................ 3-31
Table 3.8 – Model Numbers for 2 to 43 Amp GV3000/SE Bookshelf Drives.......... 3-34
Table 3.9 – Wiring Signal and Control I/O to the RMI Board Terminal Strip .......... 3-42
Table 4.1 – Analog Output Source Selections for r.001, r.004, and r.007 ................ 4-2
Table 4.2 – Regulator Operating Modes................................................................... 4-4
Table 4.3 – Digital Input Configuration Selections for r.030 ..................................... 4-6
Table 4.4 – Preset Speed Digital Inputs ................................................................. 4-10
Table 4.5 – Digital Outputs and Relay Outputs Configuration Selections ............. 4-10
Table 5.1 – RMI Fault Codes ................................................................................... 5-1