Rockwell Automation GV3000/SE, VTAC 7 Super Remote Meter Interface Board M/N 2SI3000 M/N 2SI3000E - Manual (Page 59)

Programming Reference 4-1
C
HAPTER
4
Programming Reference
A set of parameters used specifically with the RMI board is accessible when the RMI
board is connected to the drive. The parameters are in the Second Menu, as shown in
figure 4.1. RMI parameters have a lower case r as the first character. If the RMI board
is not properly connected, the r parameters will not be displayed.
This chapter describes the r parameters. All other drive parameters are described in
the drive software instruction manual. Use the appendix in the software manual to
record the r parameter settings for your configuration.
Note that vector regulation (including U parameters) does not apply to VTAC 7 drives.
Figure 4.1 – Parameter Menu Structure
)LUVW 0HQX
*HQHUDO 3DUDPHWHUV
3  3
(UURU /RJ
3DVVZRUG PXVW EH HQWHUHG
LQWR 3 WR DFFHVV WKHVH
SDUDPHWHUV
6HFRQG 0HQX
*HQHUDO 3DUDPHWHUV
3  3
9ROWV+HUW]
3DUDPHWHUV
+  +
9HFWRU
3DUDPHWHUV
8  8
50,
3DUDPHWHUV
U  U
(QWHU SDVVZRUG LQWR 3
3 8(& 3 8+ GHIDXOW
,I RSWLRQDO 50, ERDUG LV LQVWDOOHG