Rockwell Automation GV3000/SE, VTAC 7 Super Remote Meter Interface Board M/N 2SI3000 M/N 2SI3000E - Manual (Page 9)

Introduction 1-1
C
HAPTER
1
Introduction
The optional Remote Meter Interface (RMI) board provides an extended set of
terminal strip inputs and outputs for the GV3000/SE™ drive and the VTAC 7™ HVAC
drive. When the drive control source is the terminal strip (P.000 = rE), the RMI board
can be used to provide additional speed reference selections. The RMI board also
provides an outer PI regulator that is used to adjust trim. An optional adjustable torque
(vector) or current (V/Hz) limit is available using the RMI board's analog or frequency
input.
The RMI board is programmed using a set of parameters (r.---) contained in the drive's
Second Menu. Note that version 5.0 software or later is required to use the RMI board.
The RMI board mounts below the Regulator board inside the drive using the parallel
bus connector. This connection allows only one option card to be installed. Therefore,
it is not possible to install both an RMI board and a network option board in the drive at
the same time.
This manual provides installation instructions, RMI parameter descriptions, and
troubleshooting guidelines. It is intended for qualified electrical personnel responsible
for installing and programming the drive.
1.1 Where to Find Additional Information
This manual describes the RMI board and its associated r parameters. You will also
need some of the following manuals, as appropriate for your drive. They describe drive
hardware and software:
• GV3000/SE AC General Purpose (Volts/Hertz) and Vector Duty Drive Software
Start-Up and Reference Manual (D2-3359)
• GV3000/SE AC Power Modules Hardware Reference, Installation, and
Troubleshooting (D2-3360)
• VTAC 7 User's Guide (D2-3372)
• GV3000/SE 230 VAC 1-20 HP General Purpose (Volts/Hertz) and Vector Duty Drive
Software Start-Up and Reference Manual (D2-3387)
• GV3000/SE AC Drive Hardware Reference, Installation, and Troubleshooting,
1-20 HP @ 230 VAC (D2-3388)
• GV3000/SE 460 VAC 75-200 HP General Purpose (Volts/Hertz) and Vector Duty
Drive Software Start-Up and Reference Manual (D2-3391)
• GV3000/SE AC Drive Hardware Reference, Installation, and Troubleshooting
75-200 HP @ 460 VAC (D2-3392)