Dell PowerEdge C8000 - Manual (Page 156)

156 Installing System Components
Installing a Sled
1 Orient the sled so that the release latch is in the bottom of the sled. See
Figure 3-6.
2 Slide the new sled into the enclosure until the sled is fully seated and the
release latch snaps into place. See Figure 3-6.
Sled Blank
CAUTION: To ensure proper airflow in the system, if a module is removed it
should be immediately replaced with another sled or sled blank.
The information in this section include replacement procedures for the
double-wide and single-wide sled blank.
Removing a Double-Wide Sled Blank
Squeeze and hold the release latches and slide the blank out of the enclosure.
See Figure 3-7.
Figure 3-7. Removing and Installing a Double-Wide Sled Blank
1 release latches (2) 2 double-wide sled blank
1
2