Dell PowerEdge C8000 - Manual (Page 204)

204 Installing System Components
Figure 3-41. Removing and Installing the MegaRAID SAS 9265-8i RAID Battery
Installing the MegaRAID SAS 9265-8i RAID Battery
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Place the RAID battery into the hard-drive LED board assembly. See
Figure 3-41.
2 Replace the three screws securing the RAID battery. See Figure 3-41.
3 Replace the hard-drive LED board assembly. See "Installing the Hard-
Drive LED Board Assembly" on page 192.
4 Connect the RAID battery cable to the MegaRAID SAS 9265-8i card.
5 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180.
6 Replace the sled. See "Installing a Sled" on page 156.
1 M2.5 screws (3) 2 MegaRAID SAS 9265-8i RAID battery
3 bracket
2
1
3