Dell PowerEdge C8000 - Manual (Page 183)

Installing System Components 183
Figure 3-28. Removing and Installing the Sled Cover
5 Remove the rear hard-drives. See "Removing a Hard-Drive Carrier Located
on the Sled Tray" on page 169.
6 Remove the interposer extender. See "Removing the Interposer Extender"
on page 313.
NOTE: To prevent damage to the connector pins, you must remove the rear hard-
drives and interposer extender before disconnecting the twin axial cable.
7 Disconnect the twin axial cable.
a Remove the cable screw . See Figure 3-29.
b Pull the twin axial cable straight out while being careful no to bend
any connector pins in the process.
NOTE: As you pull the cable, keep it evenly aligned to avoid bending any connector
pins.
1 M3 screws (4) 2 sled cover
3 expansion card riser
1
2
3