Dell PowerEdge C8000 - Manual (Page 266)

266 Installing System Components
h Place the air baffle into the sled cover aligning the holes on the air
baffle with the screw holes on the sled cover. See Figure 3-78.
i Replace the two screws securing the air baffle to the sled cover.
See Figure 3-78.
2 Install the back Xeon Phi 5110P/7120P card.
CAUTION: If you are installing a new Xeon Phi 5110P/7120P card, ensure that the
back GPGPU card riser is installed on the sled cover with the proper screw holes.
If the GPGPU card riser is not installed with the correct screw holes, the GPGPU
card will not seat properly into the riser connector. Be sure the card riser is
installed through the "type A" screw holes. See "Installing the Back GPGPU Card
Riser" on page 271 for the location of the screw holes.
a
Remove the bracket from the Xeon Phi card. See Figure 3-87.
b Align the mounting brackets with the screw holes on the back Xeon
Phi card. See Figure 3-86.
c Replace the four screws securing the two mounting brackets.
See Figure 3-86.
d Connect the power cables to the card. Press down on the locking tab
to secure the power cables. See Figure 3-85 or Figure 3-81 cable
routing diagram.
e Route the cables along the inside wall of the sled cover and secure the
cables to the retaining clips.
f Holding the back Xeon Phi card assembly, position the card so that the
card edge connector aligns with the back GPGPU card riser connector
on the sled cover. See Figure 3-84.
g Insert the card edge connector firmly into the riser connector until the
card is fully seated. See Figure 3-84.
h Replace the four screws securing the back card assembly to the sled
cover. See Figure 3-84.
i Place the air baffle into the sled cover aligning the holes on the air
baffle with the screw holes on the sled cover. See Figure 3-83.