Dell PowerEdge C8000 - Manual (Page 224)

224 Installing System Components
2 Install the back NVIDIA Tesla M2090 GPGPU card.
a Align the mounting brackets with the screw holes on the back GPGPU
card. See Figure 3-56.
b Replace the four screws securing the two mounting brackets.
See Figure 3-56.
c Connect the emergency throttling cable to the back GPGPU card.
See Figure 3-56.
d Connect the power cables to the back GPGPU card. Press down on the
locking tab to secure the power cables. See Figure 3-55 or Figure 3-51
cable routing diagram.
e Route the cables along the inside wall of the sled cover and secure the
cables to the retaining clips.
f Holding the back GPGPU card assembly, position the card so that the
card edge connector aligns with the back GPGPU card riser connector
on the sled cover. See Figure 3-54.
g Insert the card edge connector firmly into the riser connector until the
card is fully seated. See Figure 3-54.
h Replace the four screws securing the back GPGPU card assembly to
the sled cover. See Figure 3-54.
i Place the air baffle into the sled cover aligning the holes on the air
baffle with the screw holes on the sled cover. See Figure 3-53.
j Replace the two screws securing the air baffle to the sled cover.
See Figure 3-53.
3 Lower the top cover to the sled cover and replace the five screws securing
the top cover to the sled cover. See Figure 3-47.
NOTE: Be careful not to damage the twin axial cable on the back GPGPU card riser
when replacing the top cover. See Figure 3-47.
4 Close the sled. See "Installing the Sled Cover" on page 184.
5 Replace the sled. See "Installing a Sled" on page 156.