Dell PowerEdge C8000 - Manual (Page 182)

182 Installing System Components
2 Disconnect the emergency throttling cable from the node power
distribution board located on the sled tray. See Figure 3-27.
Figure 3-27. Disconnecting and Connecting the Emergency Throttling Cable
3 Remove the four screws securing the cover to the sled tray.
See Figure 3-28.
4 Grasp the cover at both ends and pull it up until the expansion card riser
disengages from the connector on the system board, and then turn it over.
See Figure 3-28.
1 node power distribution board on sled tray 2 emergency throttling cable
1
2