Dell PowerEdge C8000 - Manual (Page 172)

172 Installing System Components
Installing a Hard-Drive Into a Hard-Drive Carrier
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the hard-drive carrier with the new hard-drive screw holes.
See Figure 3-20.
2 Replace the four screws securing the hard-drive. See Figure 3-20.
Removing the Hard-Drive Tray
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 176 or "Removing the Sled Cover" on page 181.
3 Remove the rear hard-drives. See "Removing a Hard-Drive Carrier Located
on the Sled Tray" on page 169.
4 Remove the three screws securing the hard-drive tray. See Figure 3-21.
5 Lift the hard-drive tray at an angle and slide the standoff holes on the
hard-drive tray out of the sled tray standoffs. See Figure 3-21.