Dell PowerEdge C8000 - Manual (Page 174)

174 Installing System Components
MicroSD Card
The installation and removal procedures for the MicroSD card in the two
types of sled are similar. Following is an example showing the replacement
procedure of an MicroSD card in a double-wide compute sled with
front-access 2.5-inch hot-plug hard-drives.
Removing a MicroSD Card
1 Power down the sled using OS commands or the Baseboard Management
Controller, and ensure that the sled's power is off.
When a sled is powered off, its front-panel power indicator is off.
See Figure 1-1.
2 Pull up on the sled release latch at the bottom of the sled to disengage the
sled from the server enclosure. See Figure 3-22.
3 Using the handle, slide the sled out slightly until you have access to the
MicroSD card slot. See Figure 3-22.
4 Press the MicroSD card in to release it from the slot and remove the card.
See Figure 3-22.
Figure 3-22. Removing and Installing a MicroSD Card
1
2
3 4