Interposer extender, Removing the interposer extender – Dell PowerEdge C8000 User Manual

Page 313

Advertising

Installing System Components

313

Interposer Extender

The following table lists the types of interposer extenders supported for a

specific system board model.

NOTE:

For information about identifying the sled’s system board model number,

see "Identifying System Board Model Number" on page 348.

Removing the Interposer Extender

CAUTION:

Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.

1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on

page 176 or "Removing the Sled Cover" on page 181.

3 Remove the rear hard-drives. See "Removing a Hard-Drive Carrier Located

on the Sled Cover" on page 165.

4 Remove the hard-drive tray. See "Removing the Hard-Drive Tray" on

page 172.

5 Press down the cable-locking tab and disconnect the power cable from the

interposer extender. See Figure 3-117.

6 Remove the two screws securing the interposer extender to the sled tray.

See Figure 3-117.

7 Grasp the interposer extender by its edges and carefully remove it from the

system board connector.