Dell PowerEdge C8000 - Manual (Page 167)

Installing System Components 167
3 Using the strap handle, pull the hard-drive carrier out of the drive bay.
See Figure 3-17.
Figure 3-17. Removing and Installing a Hard-Drive Carrier Located in the Sled Cover
Installing a Hard-Drive Carrier on the Sled Cover
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the hard-drive carrier to the drive bay, and then slide the hard-drive
carrier into the drive bay until the drive is fully seated. See Figure 3-17.
2 Insert the drive-bay cover into the notch on the sled cover and close the
drive-bay cover. See Figure 3-16.
3 Push the cover down until it snaps into place. See Figure 3-16.
4 Replace the sled. See "Installing a Sled" on page 156.
1 strap handle 2 2.5-inch hard-drive carrier
1
2