Dell PowerEdge C8000 User Manual
Page 318
Advertising
318
Installing System Components
6 Disconnect all cables from the node power distribution board (NPDB).
See Figure 3-119. When you disconnect the power cable, press down the
cable-locking tab and disconnect the power cable from the NPDB.
Note the routing of the cable on the sled as you remove them from the sled
tray. You must route these cables properly when you replace them to
prevent the cables from being pinched or crimped.
7 Remove the four screws securing the NPDB to the sled tray.
8 Lift the NPDB out of the sled tray. See Figure 3-119.
Figure 3-119. Removing and Installing the Node Power Distribution Board
1
power cable
2
system board control cable
3
M3 screws (4)
4
BMC management cable
5
I2C cable
6
node power distribution board
6
3
1
2
5
4
Advertising