Dell PowerEdge C8000 - Manual (Page 251)

Installing System Components 251
Installing the NVIDIA Tesla K20 GPGPU Cards
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION: Expansion cards can only be installed in the slots on the expansion
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
1 Install the front NVIDIA Tesla K20 GPGPU card.
a Align the mounting brackets with the screw holes on the front
GPGPU card. See Figure 3-72.
b Replace the four screws securing the two mounting brackets.
See Figure 3-72.
c Connect the emergency throttling cable to the front GPGPU card. See
Figure 3-70 or Figure 3-71 cable routing diagram.
d Connect the power cables to the front GPGPU card. Press down on
the locking tab to secure the power cables. See Figure 3-70 or
Figure 3-71 cable routing diagram.
e If applicable, route the cables and secure the cables to the retaining
clips.
f Holding the front GPGPU card assembly, position the card so that the
card edge connector aligns with the front GPGPU card riser connector
on the sled cover. See Figure 3-69.
g Insert the card edge connector firmly into the riser connector until the
card is fully seated. See Figure 3-69.
h Replace the four screws securing the front GPGPU card assembly to
the sled cover. See Figure 3-69.
i Place the air baffle into the sled cover aligning the holes on the air
baffle with the screw holes on the sled cover. See Figure 3-68.
j Replace the two screws securing the air baffle to the sled cover.
See Figure 3-68.