Dell PowerEdge C8000 - Manual (Page 180)

180 Installing System Components
4 Remove the four screws securing the front cover. See Figure 3-26.
5 If a hard-drive backplane is installed in the front cover, disconnect all
cables from the backplane before proceeding to next step.
6 Lift the cover from the sled tray. See Figure 3-26.
Figure 3-26. Removing and Installing the Front Cover
Installing the Front and Back Sled Covers
NOTE: It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
1 Check that all cable connections are secure.
2 Place the front cover on top of the sled tray, aligning the notches in the
front cover with the corresponding tabs in the sled tray. See Figure 3-26.
3 If an expansion card is installed, make sure the expansion card riser is
firmly seated.
4 If a hard-drive backplane is installed, connect all cables to the backplane
and proceed to next step.
1 M3 screws (4) 2 front cover
1
2