System board v1.2 jumper settings – Dell PowerEdge C8000 User Manual
Page 361
Advertising
Jumpers and Connectors
361
System Board V1.2 Jumper Settings
Figure 5-3. System Board V1.2 Jumper Settings
Table 5-3. System Board Jumper Settings
Item
Jumper
Setting
Description
1
Service mode
(default)
The flash security setting is enabled.
The flash security and NVRAM clear
signal is disabled.
2
NVRAM clear
(default)
The configuration settings are retained at
system boot.
The configuration settings are cleared at
the next system boot.
3
ME firmware
recovery
(default)
The ME firmware recovery jumper is
disabled.
The ME firmware recovery jumper
enables ME firmware recovery mode.
4
BIOS recovery
(default)
The BIOS recovery jumper is disabled.
The BIOS recovery jumper enables the
BIOS flash memory special recovery
mode.
2
3
4
5
6
1
Advertising