Dell PowerEdge C8000 User Manual
Page 265
Installing System Components
265
1 Install the front Xeon Phi 5110P/7120P card.
a
Remove the four screws securing the card bracket and lift the bracket
from the new card. Save the bracket for future use. See Figure 3-87.
Figure 3-87. Removing the Xeon Phi 5110P/7120P Card Bracket
b
Align the mounting brackets with the screw holes on the front Xeon
Phi card. See Figure 3-82.
c
Replace the four screws securing the two mounting brackets.
d
Connect the power cables to the front Xeon Phi card. Press down on
the locking tab to secure the power cables. See Figure 3-80 or
Figure 3-81 cable routing diagram.
e
Holding the front Xeon Phi card assembly, position the card so that
the card edge connector aligns with the front GPGPU card riser
connector on the sled cover. See Figure 3-79.
f
Insert the card edge connector firmly into the riser connector until the
card is fully seated. See Figure 3-79.
g
Replace the four screws securing the front card assembly to the sled
cover. See Figure 3-79.
1
screws (4)
2
card bracket
3
Xeon Phi 5110P/7120P card
1
2
3