Dell PowerEdge C8000 - Manual (Page 127)

Using the System Setup Program 127
0224 Embedded Video
Controller
Enables the onboard video controller as the primary
video device.
0225 Embedded Video
Controller
Disables the onboard video controller.
022D Boot Mode Enables booting to Unified Extensible Firmware
Interface (UEFI) capable operating systems.
022E Boot Mode Enables booting to legacy mode, ensures compatibility
with operating systems that do not support UEFI.
0231 Active Processor
Cores
Four cores of the processor are enabled This applies to
Quad-core processors only.
0232 Active Processor
Cores
Two cores of the processor are enabled. This applies to
Quad-core and Dual-core processors.
0233 Active Processor
Cores
Single core of the processor is enabled. This applies to
Quad-core and Dual-Core processors.
024B C States When enabled, the processor can operate in all
available Power C States. (default)
024C C States When disabled, there are no C states available for the
processor.
024D Pause on Errors Enables the BIOS from prompting for F1/F2 on error.
BIOS pauses at F1/F2 prompt.
024E Pause on Errors Disables the BIOS from prompting for F1/F2 on error.
BIOS pauses at F1/F2 prompt.
024F Quiet Boot Enables the display of the splash or summary screen,
rather than the detail of the POST flow.
0250 Quiet Boot Disables the display of the splash or summary screen.
The user is able to see the detail of the POST
messages.
0251 N/A The NIC1 is used for PXE boot, followed by NIC2.
0252 N/A The NIC2 is used for PXE boot, followed by NIC1.
0254 3F8h/2F8h Sets the back serial port address to 0x3F8 and internal
serial port address to 0x2F8
Table 2-1. D4 Token Table (continued)
Token Setup Option Description