Dell PowerEdge C8000 - Manual (Page 174)

174 Using the System Setup Program
PMC PDU
Firmware
Version read-only string v PDU firmware version
PDU Serial
Number read-only string v PDU serial number,
only supports when
PDU version is
6.00.05 or later
PDU State read-only values:
ok, error,
bootLoader
v PDU state
PDU Power
State read-write values:
on/off
v PDU power state
PDU Default
Power State read-write values:
on/off
v PDU Default Power
State
PDU Power
Consumption read-only integer v Total PSU power,
Unit:W
pmc Initiate
Upload read-write vaules:
pmc, config,
pdu, psu1,
psu2,
psu3, psu4,
psu5, psu6
v v Initiate upload
pmc psu
Configuration read-write values:
x4n2, x5n1
v PSU configuration,
x4n2: X+N=4+2
x5n1: X+N=5+1
Table 2-24. PMC SNMP MIB
Category Object Name Read/Write Value Type Operation
FW Safe
Boot FW Note