Dell PowerEdge C8000 - Manual (Page 169)

Using the System Setup Program 169
PMC Configuration Information
The PMC configuration information is stored in the PMC board's internal
EEPROM. You must use TFTP server to retrieve the configuration data and
then use Notepad or a text editor to view or change the configuration data.
For example, a configuration data should have the following information:
By default, the PMC controller uses DHCP to acquire an IP address. The
system MUST follow the same DHCP retry mechanism that exists in the
BMCs (any parameter needed for this MUST be stored in the configuration
file). DHCP client MUST retry forever.
CONNECT.TYPE=STATIC/DHCP
IP=192.168.0.120
NETMASK=255.255.255.0
GATEWAY=192.168.0.1
TRAP.DESTINATION1=0.0.0.0
TRAP.DESTINATION2=0.0.0.0
TRAP.DESTINATION3=0.0.0.0
TRAP.DESTINATION4=0.0.0.0
TRAP.DESTINATION5=0.0.0.0
SNMP.RD.COMMUNITY.STR=public
SNMP.RW.COMMUNITY.STR=private
MANAGE.ACSOCKET.A.DEFAULT.POWER=ON/OFF
MANAGE.ACSOCKET.B.DEFAULT.POWER=ON/OFF
MANAGE.ACSOCKET.C.DEFAULT.POWER=ON/OFF
MANAGE.PDU.DEFAULT.POWER=ON/OFF
MANAGE.PSU.CONFIGURATION=5+1