Dell 3115cn Color Laser Printer - Manual (Page 235)

Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless
network settings are reset to their default values.
TCP/IP
Purpose:
To specify the TCP/IP settings for the wireless network. The change becomes effective after the printer is
turned off and then on again.
Values:
IP Mode* 1 Dual Stack
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode* 3
Uses IPv6 to set the IP address.
IPv4 Get IP Address AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the
keys on the operator panel.
Subnet Mask
Sets the subnet mask.
Gateway Address
Sets the gateway address.
Reset IPsec* 2
Disables IPsec.
* 1 Only displayed when an optional multi-protocol card is installed on the printer.
* 2 Only displayed when IPsec is enabled.