Removing the used fuser unit, How to replace the fuser unit – Dell 3115cn Color Laser Printer User Manual
Page 461
How to replace the Fuser Unit
CAUTION:
To prevent electric shock, always turn off the multifunction printer and
disconnect the power cable from the grounded outlet before performing maintenance.
CAUTION:
Before performing any of the following procedures, read and follow the safety
instructions in your Owner's Manual or Product Information Guide.
NOTICE:
To protect the drums of the print cartridges against bright light, close the front cover within
five minutes. If the front cover remains open for more than five minutes, print quality may
deteriorate.
NOTE:
Remove any print jobs from the output tray, and close the multipurpose feeder before opening
the front cover.
Dell fuser unit is available only through Dell. To order by phone, see "
Contacting Dell
" in the Owner's Manual
or in this manual.
Dell recommends Dell fuser unit for your multifunction printer. Dell does not provide warranty coverage for
problems caused by using accessories, parts, or components not supplied by Dell.
Removing the Used Fuser Unit
CAUTION:
To avoid burns, do not replace the fuser unit immediately after printing, as the
fuser unit gets very hot during this process.
Turn off the multifunction printer and wait for 30 minutes for the fuser unit to cool down before
removal.
1.
Push the button (right side) and open the front cover.
2.