Dell 3115cn Color Laser Printer - Manual (Page 325)

4.
Use to find the status or use the number keypad to enter the value for the option you have
selected.
5.
Press to save the selection. 6.
Press Back to return to the previous screen. 7.
If necessary, repeat steps 4 through 7. 8.
To return to the standby mode, press Cancel . 9.
Available Fax Settings Options
You can use the following settings options for configuring the fax system:
Option Description
Interval
Timer You can specify the interval time (3-255 minutes) of the resend attempts.
Number of
Redial You can specify the number of redial attempts, 0-9. If you enter 0, the multifunction printer
will not redial.
Int. of
Redial Your multifunction printer can automatically redial a remote fax machine if it was busy.
Intervals from 1-15 minutes can be entered.
Ans Select You can select the default fax receiving mode.
· TEL Mode (manual receive mode): Automatic fax reception is turned off. You can receive a
fax by picking up the handset of the external telephone and then pressing the remote
receive code, or by setting OnHook to On (you can hear voice or fax tones from the remote
machine) and then pressing Start .
· FAX Mode (automatic receive mode)
· TEL/FAX Mode: When the multifunction printer receive an incoming a fax, the external
telephone rings for the time specified in Auto Ans. TEL/FAX, and then the multifunction
printer automatically receive a fax. If incoming data is not a fax, the multifunction printer
beeps from the internal speaker.
· Ans/FAX Mode: The multifunction printer can share one telephone line with an answering
machine. In this mode, the multifunction printer will monitor the fax signal and pick up
the line if there are fax tones. If the phone communication in your country is serial, this
mode is not available.
· DRPD Mode: Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctive
ring service must be installed on your telephone line by the telephone company. After the
telephone company has provided a separate number for faxing with a distinctive ring
pattern, configure the fax setup to monitor for that specific ring pattern.
Auto
Answer Fax The multifunction printer answers an incoming call and automatically goes into the receive
mode. The number of rings before the multifunction printer answers can be set in the Auto
Answer Fax option. If the user memory is full, the multifunction printer is changed to the Tel
mode.
Auto Ans.
TEL/FAX The multifunction printer can share one telephone line with an external telephone. In this
mode, the multifunction printer will monitor the fax signal and pick up the line if there are
fax tones. If the phone communication in your country is serial, this mode is not available.