Dell 3115cn Color Laser Printer - Manual (Page 238)

Auto*
Automatically sets the frame type.
Ethernet II
Uses the Ethernet II frame type.
Ethernet 802.3
Uses the IEEE802.3 frame type.
Ethernet 802.2
Uses the IEEE802.2 frame type.
Ethernet SNAP
Use the SNAP frame type.
IP Filter (IPv4)
Purpose:
To specify that data received from certain IP addresses through the wireless network is blocked. You can set
up to five IP addresses. The change becomes effective after the multifunction printer is turned off and then
on again.
Values:
IP Filter* 1 No. n/Address (n is 1-5.)
Sets the IP address for Filter n.
No. n/Mask (n is 1-5.)
Sets the mask for Filter n.
No. n/Mode (n is 1-5.) Off*
Disable the IP Filter feature for Filter n.
Accept
Accepts an access from specified IP address.
Reject
Rejects an access from specified IP address.
* 1 This item is only available for LPD or Port9100.
Initialize NVM
Purpose:
To initialize wireless network data stored in NVRAM.
Adobe Protocol