Sony AIWA NSX-V50 - Manual (Page 34)

TAPE PLAYBACK
BASIC OPERATIONS
TAPE/ —
DECK 1/2 Ì
REV MODE ■
J ?
^►►
MUSIC SENSOR
If there is a 4-second or longer blank between each track, the
search for the beginning of the current or next track during
playback can be easily made.
When the ► of the button is illuminated, press the ►►
button to move to the next track or the button to move to the
beginning of the current track.
When the ◄ of the button is illuminated, press the ◄◄
button to move to the next track, or the ►► button to move to
the beginning of the current track.
The search function uses a music sensor that may not be able
to detect tracks for tapes with:
• blanks of less than 4 seconds between tracks.
• noisy blanks.
• long passages of low-end sound.
• low overall recording levels.
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1 Insert tapes into decks 1 and 2.
2 Press the TAPE/DECK1/2 button to select the
deck to be played back first.
3 Press the REV MODE button to select
4 Press the <>■ button to start playback.
Playback continues until the ■ button is pressed.
□
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs on
the cassette tape after recording with a screwdriver or other
pointed tool. -* * ES
(a) Side A/® Tab for side A
To record on the tape again, cover the tab openings with
cellophane tape, etc. (On CrOi tapes, take care not to cover
the Cr02 tape detection slot ©.)
• 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
• Take up any slack in the tape with a pencil or similar tool before
use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape recorded
with the DOLBY NR system, turn on the DOLBY NR system.
34