Sony AIWA NSX-V50 - Manual (Page 44)

RECORDING
AI EDIT RECORDING
EDIT/ —
CHECK
. ►►------- 1 ■ I
-'R
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK to select side A or B,
and press the or ►► button repeatedly. -* ES
DISPLAY
© Tape side
@ Program number
@ Programmed track numbers
© Track number
(3;
—i-ui.- .
............
[
I I _H
Y .
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5 of page 42,
you can add tracks from other discs in the CD compartment.
1 Press the EDIT/CHECK button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numeric buttons to select tracks.
[ a TI goes out and IPRGMI starts flashing on the display.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape’s specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
• Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
• The Al EDIT function cannot be used with discs containing 31
tracks or more.
—
PROGRAMMED EDIT RECORDING
EDIT/CHECK
cp
j
ionoSii
i r \ r'" 1 m
i|^ —^|i|
1/
Vi
r T i
t
___
u
44
iPRGMlfE^
[ ” '31
.< i>. -J_ —j
The PROGRAMMED EDIT function enables CD recording while
checking the remaining time on each side of the tape as the
tracks are programmed.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
Use the remote control from steps 3 to 8.
1 Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded first facing the
foreground.
2 Press the CD button and load the disc(s).
3 Press the EDIT/CHECK button twice.
“EDIT” lights up and “PRGM” flashes on the display.
To be continued.