Sony AIWA NSX-V50 - Manual (Page 54)

SETTING THE TIMER
1 ,
The unit can be turned on at the specified time every day with
the built-in timer.
Preparation
Make sure the clock is set correctly. (See page 14.)
1 Press the TIMER button on the remote control
once to display 0 , and press the II SET button
within 4 seconds.
© is displayed, and the hour flashes.
1
TIMER
c'ci
'
' I ' / /
L. LJ
• ' '
I J. I I I '
. . . . ■
(DOWN UP>W SET
I I
I.
I ■ J n
' ■ - I U M
I I l \ / l i n .
I J L I I ! _ I y ■ ...
DECK 1/2 BAND
[ TAPE I [ TUNFR \ [ video AU x ) [ C D \
(DOWN UPMT
hurl ©i« I : i n
I I.
u
T T n ■ '
I ± I I O n ■ . .
If you do not press the II SET button within 4 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the DOWN or ►M UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source name flashes alternately in the display for 4 seconds.
3 Within 4 seconds, press one of the function
buttons to select a source.
“TIMER” and the selected source name flash alternately for 4
seconds. At this time, the selected function button does not
light up.
• If this step is not completed within 4 seconds, repeat from
step 1.
• If the TUNER button is pressed, the band cannot be selected
in this step.
4 Within 4 seconds, seiect the duration for the
timer-activated period with the DOWN or
UP button.
The duration for the timer-activated period can be set between
10 and 240 minutes in 10-minute steps.
• If this step is not completed within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the voiume and tone.
© remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
To check the specified time and source
Press the TIMER button on the remote control. The timer-on
time and the selected source name are displayed for 4 seconds.
However, the duration for the timer-activated period will not be
displayed.
‘6sTANDBY/ON
^OWE^ 0 «W
¡■■1
■V i n - - i r
I I.J-
© ©
54