CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 101)

9145EMP NID Software User’s Manual Utilities
Set Date and Time
86
7.1 Set Date and Time
To set the correct date and time, type 1 and press Enter. Type the current date and time in DD/
MM/YYYY HH:MM:SS format. Press Enter to confirm the setting. Note that SNTP will overwrite
the setting on the next poll if SNTP is enabled.
7.2 Reset Configuration To Default
To reset the configuration to the default settings, type 2 and press Enter. Type Y and press
Enter. All values, with the exception of Manager IP Address, Subnet Mask, Default Gateway,
Management Port, Manager's VLAN Configuration and ID, Test IP and Subnet Mask, and User
and Network Port settings will be returned to factory settings and the system will be reset.
NOTE: During reset all host connections will be terminated.
7.3 Change Password
To change your current password, from the Utilities Menu, type 3 and press Enter. The Change
Password screen (Figure 7-2) opens.
1. Type the current password and press Enter.
2. Type the new password and press Enter.
3. Retype the new password and press Enter.
Figure 7-2 Change Password screen
Canoga Perkins Corp. Ethernet Network Interface Device 16-JUN-2011
9145EMP-761-4-0 V40.43 Canoga 9145EMP 32 device 11:20:59
-------------------------------CHANGE PASSWORD---------------------------------
Please enter your current password : *****
Please enter your new password : *****
Please enter your new password again : *****
------------------------------------Messages-----------------------------------