CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 72)

Port Information 9145EMP NID Software User’s Manual
Port Configuration
57
5.2.2.1 Configuring Link Loss Forwarding
Link Loss Forwarding (LLF) allows the 9145EMP to signal attached equipment that a link on the
corresponding port has gone down. This is done by bringing down the attached link. Each user
port has an attribute that tells the system if the port participates in Link Loss Forwarding.
For this release, LLF is supported for Network to User only. When you select Network to User,
the User Ports that participates in LLF will be disabled if the Network Port goes down.
To configure LLF, on the Functional Configuration screen for those network port modules, type 12
and press Enter. The LLF Configuration screen opens.
Figure 5-6 LLF Configuration screen
1. To enable or disable LLF on a particular user port, type the number of the port and press
Enter.
2. To configure LLF, type 5 and press Enter. Press the Space bar to select Enabled or
Disabled.
3. To accept the configuration, type A and press Enter.
4. Press Esc to return to the Functional Configuration screen
Canoga Perkins Corp. Ethernet Network Interface Device 23-NOV-2011
9145EMP-761-4-0 V40.43 Canoga 9145EMP 32 device 11:20:59
--------------------------------LLF CONFIGURATION------------------------------
1) User 1 LLF Participation Enabled
2) User 2 LLF Participation Enabled
3) User 3 LLF Participation Disabled
4) User 4 LLF Participation Disabled
5) LLF Configuration Disabled
Select [1-5]:
------------------------------------Messages-----------------------------------