CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 209)

9145EMP NID Software User’s Manual Configuring EVC
EVC Configuration
194
12.2.3.1 Mapping a Queue on the User Port in C-VID
C-VID based classification must be enabled for the user ports, using the Class of Service queue
configuration menu (Figure 10-3), for this functionality to work. Otherwise, the screen will not be
available.
If you selected C-VID for the User port, you can use the User Port Tagged Packet Classifier
Mapping screen (C-VID Mode) (Figure 12-12) to select a port, change the queue assignment,
and view the queue assignment of a particular C-VLAN or range of C-VLANs. The screen
displays the first 40 C-VID queue assignments. To view more, use step 3, below.
1. To change User port, on the User Port Tagged Packet Classifier Mapping screen (C-VID
Mode), type 1 and press Enter. Use the Space bar to select a User port, and then press
Enter.
2. To change the queue assignment, type 2 and press Enter.
• Enter a C-VLAN ID (C-VID) or a range of IDs from 1-4094 and press Enter.
• Enter the queue ID (1-3) for Q1-Q3 or 4 for LLQ. and press Enter. The queue
assignment changes to the new value. (Only a queue that is enabled can be
selected. To enable or disable a queue, see “Queues Configuration on Network
Ports” on page 119.)
3. To view the queue assignment of a particular C-VID (other than the first 40 already shown
on your screen), type 3 and press Enter.
• Enter a C-VLAN ID (C-VID) and press Enter. The screen displays a page of 40 C-
VIDs, including the C-VID you selected.