CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 203)

9145EMP NID Software User’s Manual Configuring EVC
EVC Configuration
188
2. Press the Space bar to scroll through the list and highlight the record to modify. When the
record you want to modify is highlighted, press Enter. The Modify EVC Configuration
Record screen (Figure 12-5) opens.
Figure 12-5 Modify EVC Configuration Record screen
3. To change the Administrative State, type 1 and press Enter. Press the Space bar to select
Up or Down, and press Enter.
4. To change the statistics display, type 2 and press Enter. Press the Space bar to select S-
VLAN, C-VLAN, or Disabled, and press Enter.
If you set the statistics mode for a service multiplexing record to C-VLAN then you can
see the service multiplexing statistics detailed at C-VLAN level (as in Figure 12-15).
To change the S-Tag PCP Value, type 3 and press Enter. Press the Space bar to select
Map from CVID, Static or Copy from Ingress, and press Enter.
5. To change the Static/Default PCP value for the S-Tag, type 4 and press Enter.
6. To change the T-Tag PCP value, type 5 and press Enter. Press the Space bar to select
Map from CVID, Static or Copy from Ingress, and press Enter.
7. To change the Static/Default PCP value for the T-Tag, type 6 and press Enter.
8. To modify CoS to Queue mapping, type 7 and press Enter. For steps, see “Mapping a
Queue on the User Port in C-VID” on page 194.
9. To modify the assigned policer profile, or allocate new policers to EVC or EVC/COS, type
8 and press Enter. The VLAN/COS Policing screen (Figure 12-6) opens. Note that if the
EVC belongs to a User port for which policing is enable at the port level, this screen is
read only and displays the port-level policer information.
Canoga Perkins Corp. Ethernet Network Interface Device 21-MAR-2011
9145EMP-761-4-0 V40.43 03:21:18
-----------------------MODIFY EVC CONFIGURATION RECORD--------------------------
S-VLAN ID: 10 TTag: Enable 5
User Interface: USR1
Network Interface: NET1
Name: soam
Multiplexing type: Service Mux
Operational state: DOWN
1) Administrative state: UP
2) Statistics: Disabled
3) S-Tag PCP Value: Copy from ingress 4) Static/Default PCP Value: N/A
5) T-Tag PCP Value: Copy from ingress 6) Static/Default PCP Value: N/A
7) CoS to Queue Mapping
8) Assign Policer Profile
9) C-VLAN Translation 10) CVID to S-Tag PCP Mapping
11) P-Bit Translation 12) CVID to T-Tag PCP Mapping
13) View/modify C-VLAN List
Select [1-13] for attributes:
------------------------------------Messages-----------------------------------