CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 169)

9145EMP NID Software User’s Manual Service OAM
Maintenance End Points
154
Figure 11-20 Create a New Maintenance End Point screen (Y.1731)
11.6.3 Delete a Maintenance End Point
When you delete a Y.1731 Maintenance End Point, it is also deleted from the AIS client list.
1. On the Maintenance End Point List screen (Figure 11-18), type D and press Enter. The
current MEP is highlighted.
2. Press the Space bar to scroll through the list and highlight the entry you wish to delete.
3. Press Enter to delete the highlighted MEP.
11.6.4 Modify a Maintenance End Point
1. On the Maintenance End Point List screen (Figure 11-18), type E and press Enter. The
current MEP is highlighted.
2. Press the Space bar to scroll through the list and highlight the entry to modify.
3. When the MEP you want to modify is highlighted, press Enter. The Maintenance End
Point Attributes screen for that MEP opens (Figure 11-21 for 802.1ag or Figure 11-22 for
Y.1731). The top of the screen displays the MEP attributes that you configured when the
MEP was created.
4. To change the Admin Status, type 1 and press Enter. Select Enabled or Disabled and
press Enter.
5. To change CCM Transmit Status, type 2 and press Enter. Select Enabled or Disabled and
press Enter.
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2011
9145EMP-761-4-0 V40.43 Canoga 9145EMP 32 device 11:20:59
----------------------CREATE A NEW MAINTENANCE END POINT------------------------
1) MEG ID 0
MEP ID: 0
3) Admin Status: Disabled
4) Direction: Down
5) Port: NET1
Select [1-5] for attributes:
------------------------------------Messages-----------------------------------