CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 115)

9145EMP NID Software User’s Manual Link OAM
OAM Control
100
9.1.6 OAM Remote Fault
This setting indicates whether a remote fault OAM PDU was sent by the peer to the 9145EMP.
9.1.7 OAM Admin State
This setting enables or disables OAM in the 9145EMP.
9.1.8 OAM Mode
Two modes can be configured in every port of the 9145EMP. In active mode, the port initiates the
autodetection procedure with the far end, and can initiate remote loopback requests. When two
ports are connected, at least one side must be in active mode. Passive mode cannot initiate
functions such as loopback or generate a critical event.
9.1.9 OAM Loopback Command
This command allows you to start or terminate an existing remote loopback.
9.1.10 Process Rx Loopback OAM PDU
This setting allows you to process or ignore incoming OAMPDU.
9.1.11 FWD Critical Event
This setting controls whether a user port will send a critical event when the corresponding
network port goes down. This setting is operational only if an All-to-One Bundling service
multiplexing is configured on the user port. The attribute is not configurable for Network Ports.
9.1.12 User Interface MIB Objects
The standard configuration parameters and their corresponding MIB objects are:
• FWD Critical Event cpDot3OamForwardCriticalEvent (cpdot3oam.my)
• OAM Admin State dot3OamAdminState (dot3oam.my)
• OAM Functions Supported dot3OamFunctionsSupported (dot3oam.my)
• OAM Loopback Command dot3OamLoopbackStatus (dot3oam.my)
• OAM Loopback Status Dot3OamLoopbackStatus (dot3oam.my)
• OAM MAX PDU Size dot3OamMaxOamPduSize (dot3oam.my)
• OAM Mode dot3OamMode (dot3oam.my)
• OAM Operational Status dot3OamOperStatus (dot3oam.my)
• OAM Remote Link Fault
• OAM Revision dot3OamConfigRevision (dot3oam.my)
• Process Rx Loopback OAMPDU dot3OamloopbackIgnoreRx (dot3oam.my)