CANOGA PERKINS 9145EMP NID Software Version 4.0 - Manual (Page 107)

9145EMP NID Software User’s Manual Software Upgrade
Swap Bank After Download and Reset
92
NOTE: All users will be logged off during the 9145EMP reset. In most cases, payload traffic
through the 9145EMP will be disrupted for only a few frames while the FPGA is programmed with
the new file.
To swap banks and reset the 9145EMP, type 2 and press Enter. Swap will be highlighted. Press
Enter. The flash memory banks will be swapped and the 9145EMP will reset.
NOTE:The software on the new inactive flash memory bank will remain in memory and not be
deleted.
Figure 8-1 Software Upgrade screen
8.3 Swap Bank After Download and Reset
Option 3 allows you to select automatically swapping banks on reset after a successful
download. Select Yes for automatically swap banks. Select No to have downloaded software
remain in the inactive bank. This option does not generate a reset.
Type 3 and press Enter. Press the Space bar to select Yes or No.
NOTE: Users will be disconnected when the 9145EMP is reset.
The setting “Swap Bank after download and reset” must be set before downloading the new
software. After you download software, the message line will read Loads xx.xx on Next Reset.
Canoga Perkins Corp. Ethernet Network Interface Device 21-MAR-2011
9145EMP-761-4-0 V40.43 Canoga 9145EMP 32 device 11:20:59
--------------------------------SOFTWARE UPGRADE-------------------------------
Time Since Last Restart 00:35:42
Version File Name File Size
Active Firmware 43.12 9145EMP-A10(P3)-43-12.ZIP 2798146
Inactive Firmware 00.00 9145EMP-A00(10G)-00-00.ZIP 2362124
Bootcode 02.20 9145EMP-B00-02-20.BIN 337562
1) Software Reset Reset
2) Swap Bank & Reset Swap
3) Swap Bank after
download and reset Yes
4) Get New File with TFTP
Select [1-4]:
------------------------------------Messages-----------------------------------