Yamaha HTR-5860 - Manual (Page 24)

CONNECTIONS
■ Connecting to an external amplifier
If you want to increase the power output to the speakers,
or want to use another amplifier, connect an external
amplifier to the PRE OUT jacks as follows.
Notes
• When audio pin plugs are eomiected to the PRE OUT jaeks for
output to an external amplifier, do not make connections to the
corresponding SPEAKERS terniitials. Set the volume of the
amplifier connected to this unit to the inaximtnn.
• The signals output through Ihc FRONT PRE OUT and
CENTER PRE OUT jacks are tiffected by the TONE
CONTROL settings.
• If SPEAKERS A is turned off and SP B is sel to ZONE B (see
page 71). signals will only he output from the FRONT PRE
OUT jacks.
•
9 m
n
PREOUT ------------------
'9 ©
,r9 @ ©
FRONT SURROUND
nt'TsF.
BACK
O
FRONT PRE OUT jacks
Front channel line output jacks.
9 SURROUND PRE OUT jacks
Surround channel line output jacks.
0 CENTER PRE OUT jack
Center channel line output jack.
o SURROUND BACK PRE OUT jacks
Surround back or presence channel line output jacks.
0 SUBWOOFER PRE OUT jack
Connect a subwoofer with built-in amplifier, such as the
YAMAHA Active Servo Processing Subwoofer System,
to this jack.
Notes
• Each PRE OUT jack outputs the same channel signals as the
correspoinling speaker terminals.
• Adjust the volume level of the subwoofer with the control on
the subwoofer. It is also possible to adjust the volume level
using the remote control (see “Mtumally adjusting speaker
levels" on page .59).
• Some signals may not be output from the SUBWOOFER PRE
OUT jack depending on Ihe SPEAKER SET (see ptige 63) and
LFE/BASS OUT (see page 64) sellings.
20