Yamaha HTR-5860 - Manual (Page 81)

REMOTE CONTROL FEATURES
Switching library codes
You can select the unit you want to operate with the
remote control by entering the library code.
1
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
YRANSi^HT
Clearing set up remote control
codes
1
Press an input selector button or ** to
select the component control for which you
want to clear the remote control code.
; r/'
2
Enter the code number “9991” or “9992” (see
the table below).
The TRANSMIT indicator on the remote control
flashes twice, and the library code is changed.
AMP library
code
(remote
control
setting)
Function
Remote
control ID (unit
setting: see
page 73)
9991
To operate this unit
using the default code. IDl
(initial setting)
9992
To operate this unit
using an alternative
code.
ID2
When using multiple YAMAHA rcceivers/arnpliners, you
may be able to operate the other components simulUmeoiisly
with the default code setting. In this case, set one of the
alternative codes to operate this unit separately.
Note
You must also make settings for the receiver/arnplifier.
2
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
TRAIiSilT.
3
Enter the code number “0000”.
The TRANSMIT indicator on the remote control
flashes twice, and the remote control code for the
selected component is cleared,
• If you do not press any button wdthin .^0 seconds after step 2,
the clearing process is canceled. If this happens, start over from
step I.
* You can clear all setup remote control codes at once by entering
the code number "9990".
77