Yamaha HTR-5860 - Manual (Page 29)

AUTO SETUP
Starting the setup
For best results, make sure the room is as quiet as possible
during the auto setup procedure (YPAO). If there is too
much ambient noise, the results may not be satisfactory.
si's
If your subwoofer has adjustable volume and crossover/lrigh cut
frequency controls, set the volume between 9 and 11 o'clock (as
view'ed on a conventional clockfacc) and set the crossover/high
cut frequency to the maximum.
Subwoofer
1
Switch on this unit and your video monitor.
Make sure the OSD is displayed.
2
Press AMP.
5
Press /\ / \/ to select “SETUP”, then press
< / > to select the desired setting.
id LIT 0
FilELliRD
UNDO
Muiopf.st.ic.
O'P all it.eiiik
To perform the auto setup procedure
(YPAO).
To reload the last auto setup (YPAO)
settings to override any manual
changes.
To undo the last auto setup (YPAO)
and re.store the previous settings.
IDIEFfiiiL!" To restore the factory preset (default)
setup parameters.
-i'c
You can choose RELOAD or UNDO only if you have
already performed the auto setup procedure.
3
Press SET MENU.
When MEMORY GUARD is set to ON, you cannot select
any other SET MENU items (sec page 60).
4
Press/\ / vr to select AUTO SETUP, then
press ENTER.
6 Press \/ to select “START”, then press
ENTER to start the setup procedure.
The screen changes as follows,
NyiOiltNy
fìuÌDi'’ìaiic
processing
of ^all .it
♦
♦
EBlliiEiilT
s 5.-'4/8.,
y|:ii ii:
iiJE
..'own
.er
25