Cisco 3825 - Manual (Page 129)

4-71
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Monitoring and Managing the Cisco 3825 Router
Show Commands for Monitoring the Cisco 3825 Router
To monitor and maintain the Cisco 3825 router, use the following commands:
Command Purpose
show atm cell-packing Displays information about Layer 2 transport
ATM cell-packing.
show cem circuit Displays summary information about the CEM
circuit state, including controller, interface and
AC.
Displays specific CEM circuit state, circuit
parameters and statistics/counters in detail.
show cem platform Displays CEM errors and information.
show controllers Displays all network modules and their interfaces.
Displays the status of the VWIC/HWIC relays
when a VWIC or HWIC is installed.
show controllers e1 Displays information about the controller status
specific to the controller hardware. It also displays
statistics about the E1 link. If you specify a slot
and a port number, statistics for each 15 minute
period will be displayed.
show controllers fastethernet slot/port Displays information about initialization block,
transmit ring, receive ring and errors for the Fast
Ethernet controller chip.
show controllers gigabitethernet slot/subslot/port Displays information about initialization block,
transmit ring, receive ring, and errors for Gigabit
Ethernet interface controllers.
show controllers t1 Displays information about the cable length,
framing, firmware, and errors associated with the
T1. With the Cisco 3825 router, this command
also displays the status of the relays on the
VWIC/HWIC.
show gsm traffic Displays traffic rates, in bits per second, at 1
second, 5 seconds, 1 minute, 5 minutes, and 1 hour
intervals for GSM data transmitted and received
over the backhaul.
show gsm-abis efficiency [history] Displays the history of the GSM efficiency
averages for compression/decompression at
1-second, 5-second, 1-minute, 5-minute, and
1-hour intervals.
show gsm-abis errors Displays error statistics counters of the GSM for
compression/decompression.
show gsm-abis packets Displays packet statistics counters of the GSM for
compression/decompression.
show gsm-abis peering [details] Displays peering status, statistics, and history of
the GSM compression/decompression.