Cisco 3825 - Manual (Page 194)

A-62
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
mode y-cable
mode y-cable
To access the command mode that allows you to manually control the relays on the voice/WAN interface
card (VWIC) or high-speed WAN interface card (HWIC), use the mode y-cable command in redundancy
configuration mode.
mode y-cable
Syntax Description This command has no parameters, it invokes the y-cable mode.
Defaults There are no default settings or behaviors.
Command Modes Redundancy configuration
Command History
Examples The following example enables y-cable mode:
Router(config)# redundancy
Router(config-r)# mode y-cable
Related Commands
Release Modification
12.2(8)MC2 This command was introduced.
12.2(15)MC1 This command was incorporated.
12.3(11)T This command was incorporated.
12.4(2)MR This command was incorporated.
Command Description
standalone Indicates whether the Cisco 3825 router is being used as a standalone
device and manually sets the relays.
standby use-interface Designates a loopback interface as a health or revertive interface.
redundancy Invokes redundancy mode.