Ipran-mib backhaul-notify-interval – Cisco 3825 User Manual

Page 181

Advertising
background image

A-49

Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide

OL-15667-03

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

ipran-mib backhaul-notify-interval

ipran-mib backhaul-notify-interval

Use the ipran-mib backhaul-notify-interval command in the global configuration mode to specify the
interval used to suppress the generation of the ciscoIpRanBackHaulRcvdUtil and the
ciscoIpRanBackHaulSentUtil notifications from the CISCO-IP-RAN-BACKHAUL-MIB.

To set the interval used to suppress notifications, use the following configuration command or the no
form of this command to remove the interval:

ipran-mib backhaul-notify-interval 60-900 seconds

Notifications are suppressed for the number of seconds specified. Notifications are not suppressed when
this keyword is set to zero. The minimum interval is one minute and the maximum is fifteen minutes.
When suppression is enabled, notifications are generated when a worse state is encountered. For
example, the following transitions generate notifications:

“acceptable” to “warning”

“warning” to “overloaded”

Later transitions to lesser states are suppressed. For example, the following transitions do not generate
notifications:

“warning” to “acceptable”

“overloaded” to “warning”

“overloaded” to “acceptable”

At the end of the specified interval, a notification is generated if the current state is different from the
state reported by the last notification.

Syntax Description

Defaults

Defaults to 0 (notifications are not suppressed).

Command Modes

Interface configuration

Command History

Examples

Router# config t

Router(config)# ipran-mib backhaul-notify-interval 60

Router(config)# ipran-mib backhaul-notify-interval 900

Router(config)# no ipran-mib backhaul-notify-interval

Router(config)# exit

ipran-mib
backhaul-notify-interval

60-900 seconds

Release

Modification

12.4(2)MR1

This command was introduced.

12.4(9)MR

Support for utilization notification was removed. This command is supported to
maintain compatibility.

Advertising