Cisco 3825 - Manual (Page 250)

A-118
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
snmp-server enable traps ipran util
snmp-server enable traps ipran util
To provide information alarms associated with backhaul utilization via Simple Network Management
Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps
ipran util command in global configuration mode. To disable ipran alarm-gsm notifications, use the no
form of this command.
snmp-server enable traps ipran util
no snmp-server enable traps ipran util
Syntax Description This command has no arguments or keywords.
Defaults This command is disabled by default. No notifications are sent.
Command Modes Global configuration
Command History
Examples The following is an example of the output generated by this command.
Router(config)# snmp-server enable traps ipran util
Related Commands
Release Modification
12.4(2)MR1 This command was introduced.
12.4(9)MR Support for utilization notification has been removed and the command is
provided only to maintain compatibility.
Command Description
snmp-server enable traps
ipran alarm-gsm Provides information alarms associated with GSM-Abis interfaces.
snmp-server enable traps
ipran alarm-umts Provides information alarms associated with UMTS-Iub interfaces.
snmp-server enable traps
ipran Enables all notifications.
ipran-mib
backhaul-notify-interval Specifies the interval used to calculate the utilization.
ipran-mib
threshold-acceptable Specifies the acceptable level of traffic.
ipran-mib
threshold-overloaded Specifies the amount of traffic that indicates the backhaul is
overloaded.
ipran-mib
threshold-warning Specifies the amount of traffic that indicates the backhaul is carrying
traffic sufficient to impact performance, but is not overloaded.